A
“Rule of Thumb” for Switch Setting
This chart offers a “Rule for Thumb” for selecting appropriate switch settings
and lubricant output rate for some basic applications. Many variables must be
considered when determining the best setting for your operating environment. Areas
of high contamination and heavy water washout generally require a slight increase
in lubricant flow rate. Because of the wide number of variables found in actual
operating environments, this chart should only be considered as a guide in making
the selection of the proper switch setting. ALWAYS AVOID OVER-LUBRICATING.
Selection
Of Switch Setting
One stroke from a typical grease gun is equal to approximately
one cubic centimetre (cc). To select the switch setting appropriate for your
application, look down the column for the desired output of lubricant, remembering
that 1cc is equal to approximately one stroke from a grease gun. The switch
setting for your selection is shown in the right most columns labeled Switch1
to Switch7.
ELECTRO-LUBER
MD 2000 Model 125 Dispensing Rate Chart
ELECTRO-LUBER
MD 2000 Model 250 Dispensing Rate Chart
ELECTRO-LUBER
MD 2000 Model 500 Dispensing Rate Chart
For
other settings or special applications,
Please contact:
C&L Supply Co.
4840 York Boulevard
Los Angeles, CA 90042
Tel: 800 4-LUBERS
Tel: 323 258-1940
Fax: 323 258-6523
Email: Info@electroluber.com
